The product can be applied directly to all metal surfaces (except stainless steel), wood, concrete, brick.
The surface to be coated should be clean, dry and degreased.
Splashes of old varnish and rust should be removed beforehand and the surface sanded.
Good surface preparation is necessary to achieve the best repair results.
Tech data
| Color |
red RAL 3020, intensive red RAL3002, yellow RAL1028,blue RAL5002, green RAL 6029, gray RAL7001,dark gray RAL7016, brown RAL8016, white RAL9010 |
| Gloss grade |
gloss |
| Yield |
1 – 2 m2/ 400 ml |
Application
- Can be applied directly to all metal surfaces (except stainless steel), wood, concrete, brick.
- Cover areas that are to remain unpainted.
- Before use, shake the container for about 2 - 3 minutes and make a test spray.
- Apply from a distance of about 25 cm.
- Apply one or two layers as needed.
- After finishing the application, it is recommended to set the aerosol with the valve down and press the button releasing the content for about 5 seconds - this will improve the re-use of the product and preserve its existing properties, as well as protect the nozzle from possible clogging.
Note: for safety purposes, always follow the data on the Material Safety Data Sheet for the product.
Coverage: 1 to 2 coats, depending on the thickness of the layer
Coating thickness: 50 to 100 μm wet film (depending on surface texture)
Drying times (at 20°C)
- dust dry: after about 5 to 8 minutes
- touch dry: after about 60 minutes
- fully dry: after about 24 hours
Caution
To maintain safety, always follow the instructions given in the MSDS for the products.
 |
VOC for mixture = 650g/L |