Advantages

• Very good adhesion to metal.
• Good hardness with high elasticity.
• Minimal shrinkage.
• Good sanding properties.

 Application

The product has very good adhesion to various substrates. It can be applied over:

• Steel and aluminum after flatting and degreasing.
• Zinc coated steel after flatting and degreasing.
• Sanded glass fibre (GFK/GRP), polyester putties, acrylic and epoxy primers and existing paint coatings in good condition.

 Caution: Do not apply the polyester resins directly on the wash primers, 1K acrylic and nitrocellulose products

Mixing ratio per weight

• Resin 100
• Activator 4

Stir very well.

Application process

1. Prepare suitable piece of glass mat, approximately 2 cm bigger than the damaged place.
2. Mix the resin with the hardener and spread it onto the cleaned surface using a brush.
3. Place the mat, press it and soak with resin using a brush. Several layers of the mat can be applied.
4. Wait approximately 40 minutes. Mechanically sand the dried laminate surface or level it up with a polyester putty. 
5. Minimum application temperature is +10°C.

 Caution: Do not pour the remains of the mixed resin and hardener back to the tin.

Sanding

Coarse sanding (dry): P80÷P120.

Drying time

35÷45 minutes at 20°C.

Temperatures below 20°C significantly increases the drying time.

Further work

Polyester laminates can be directly over coated with:

• 2K polyester body fillers and putties.
• 2K polyester spray fillers.
• 2K epoxy putties.
• 2K acrylic primers.
• 2K epoxy primers.

 General notes 

 Caution

To maintain safety, always follow the instructions given in the MSDS for the products.

VOC for mixture = 395 g/L